Experimental Physics · Circuits & experimental skills
Electric Circuits Lab
Wire meters correctly, select useful ranges, test series and parallel rules, collect an ohmic I–V data set, plot your own graph and defend every conclusion with evidence.
Resume your stored circuit evidence.
- 1 · Plan
- 2 · Series
- 3 · Parallel
- 4 · I–V data
- 5 · Graph
- 6 · Analyse
- 7 · Review
Low-voltage Circuit Laboratory
Use only the isolated low-voltage virtual supply. Plan meter connections before closing a switch.
Choose Learn Lab or Exam Arena to begin.
Investigation Notebook
Step 1 · Plan before power
Place every instrument for a reason
Research aim: use measurements to test circuit rules and determine the resistance of an ohmic conductor.
A IN THE LINE · V ACROSS · SWITCH OFF TO REWIRE
Step 2 · Series evidence
Measure, then decide what stays the same
Collect current at three positions and potential difference across the supply and each resistor. Read the instrument shown in the laboratory.
series: current is the same everywhere · Vsupply = V1 + V2
Step 3 · Parallel evidence
Track charge through the junction
Collect source and branch currents, then compare potential differences across both branches and the supply.
junction: Isource = I1 + I2 · parallel p.d.s are equal
Step 4 · Ohmic I–V data
Change one quantity; record both
Use the variable low-voltage supply to collect six pairs of current and potential difference for the test resistor.
WIDE RANGE · SEVERAL PAIRS · SWITCH OFF BETWEEN READINGS
Step 5 · Student graph
Plot current vertically against potential difference
Use your own six pairs. Enter each coordinate or select the graph to estimate it, then add a small cross.
| Reading | V / V | I / A |
|---|
Step 6 · Separate analysis paper
Read diagrams like an examiner
Use your collected evidence. Automatic scoring is labelled Suggested mark.
Step 7 · Review
Circuit Evidence Notebook
| Investigation | measurement | student reading | unit | selected range | technique record |
|---|---|---|---|---|---|
| No readings stored yet. | |||||
Progress is stored only in this browser. Real-lab transfer: use only a current-limited low-voltage school supply under teacher supervision. Never use mains electricity. Switch off before rewiring, check leads and insulation, and stop if a component or lead becomes hot.